Care And Cleaning - Klarstein 10013323 Manual De Instrucciones

EN
16
5 Plug the power lead into the supply socket, then press the green on/off switch on
the ice machine to start it - the green „run" light will be lit. The Ice Baby will start to
operate.
6 The operation of the Ice Baker is completely automatic including. water inlet, ice
making, ice transfer and ice storage.
7 If the storage container is full, the „ice full" indicator on the display panel will be
lit, and the ice machine will stop automatically. Remove the ice from the storage
container, wait for five minutes, then restart the ice maker.
8 Should the water supply be restricted or fail, the „water low" LED will be lit. The ice
maker will stop automatically. When the water supply is restored, wait for at least
five minutes, then re-start the unit.
Important Notes on Use
• If the compressor stops for any reasons such as water shortage, too much ice,
power off etcetera, don't restart it right away. You can restart it after 5 minutes in
order to protect the compressor.
• Check the connectors of the water inlet and outlet, tubes and drain regularly for
surplus water that may be present.
• When plugging in or unplugging, the plug should be held by hand and the wires
should not be dragged heavily.

CARE AND CLEANING

• Always switch off and disconnect the power supply before cleaning
• Warm, soapy water is recommended for cleaning. Cleaning agents may leave
harmful residues. Do not wash the base unit, instead wipe the exterior with a damp
cloth. Do not immerse in water,or use steam/jet washers to clean the unit.
• Check regularly the connectors of the water inlet and outlet tubes and drain the little
surplus water that may leak.
• Clean the water filter regularly with a small brush,particularly in hard water ares.
The water filter is located just inside the water inlet at the back of the appliance.
• Replace any unused water in the tank at least once every 24 hours.
• The inner removable parts and water tank should be cleaned regularly.