Tabla de contenido
Publicidad
4.
5.
distribute oil.
6.
MUFFLER AND SPARK ARRESTING SCREEN
As your unit is used, carbon deposits build up on the
spark arresting screen will not require any service.
LINE REPLACEMENT
a WARNING: Use only 0.080 inch (2 mm) diameter line.
Other sizes of line will not advance properly and will
result in improper cutting head function or can cause
serious injury.
a WARNING: Do not use other materials such as wire,
string, rope, etc. Wire can break off during cutting and
become a dangerous projectile that can cause serious
injury.
1. Press the tabs on the side of the trimmer head and
remove cover and spool.
2. Remove any remaining line.
3. Clean dirt and debris from all parts. Replace spool if it
is worn or damaged.
4. Cut 25 feet (7.6 meters) length of 0.080 inch (2 mm)
diameter trimmer line. Bend a the line at the midpoint
and insert the bend into the slot in the center rim of the
spool. Ensure line snaps into position in the slot.
A
SERVICE AND ADJUSTMENTS
serviced or replaced by your authorized service dealer.
REPLACE SPARK PLUG
Replace the spark plug each year to ensure the engine
starts easier and runs better. Set spark plug gap at 0.025
NOTE: For Canadian models only: This spark ignition
system complies with the Canadian standard ICES-002.
1. Twist, then pull off spark plug boot.
2. Remove spark plug from cylinder and discard.
3.
• For U.S. models only: Replace with Champion RCJ-6Y.
• For Canadian models only: Replace with Champion
QCJ-6Y.
4. Tighten securely with a 3/4 inch (19 mm) socket
wrench.
5. Reinstall the spark plug boot.
5. When installing new line on an existing spool, hold the
spool as shown in the illustration below.
6.
direction.
7. Position the lines in the guide slots.
7
Publicidad
Tabla de contenido
