Before Calling; For Service - KENMORE ELITE 796.3142 Manual De Uso Y Cuidado

BEFORE CALLING FOR SERVICE (continued)
Washer will not operate Control panel has powered off due to
inactivity.
Washer not filling
Washer is unplugged.
Water supply is turned off.
Controls are not set properly.
Lid is open
Circuit breaker/fuse is tripped/blown.
Control needs to be reset.
START/PAUSE was not pressed after a cycle
was set.
Extremely low water pressure.
Washer is too cold.
Filter clogged_
Inlet hoses may be kinked
Energy efficiency.
Insufficientwater supply.
The washer lid is open.
Hot and cold inlet hoses are reversed.
Water level is too low.
7i 7 _ i_ ¸¸¸ !ii_ i _ i i i iii_7_: i_i i ¸¸_,7i__ ¸ i¸_ii _ i i_,,_ ...... i _ _i_iiiiiTiiiiiiiiiiii
i _ _ _ _ iiiii _ !iiiiiiii!_]_|i_ii!iii_ii!iIiiiiiiiiiiiii!iiiiiiiii_ii!!i_!iii_i_iiiiii!!iH!_
This is normal. Pressthe POWER button to turn
the washer on.
Make sure cord is plugged securely into a
working outlet,
Turn both hot and cold faucets fully on.
Make sure the cycle was set correctly, close the
lid and press the START/PAUSEbutton.
The washer will not operate if the lid is open.
Close the lid and make sure that nothing is
caught under the lid preventing it from closing
completely,
Check house circuit breakers/fuses. Replace
fuses or reset breaker. The washer should be
on a dedicated branch circuit. The washer will
resume the cycle where it stopped once power
is restored.
Pressthe POWER button, then re-select the
desired cycle and press the START/PAUSE
buffon.
Pressthe POWER button then re-select the
desired cycle and press the START/PAUSE
button. The washer wi shut off if the START/
PAUSEbutton is not pressed within four minutes.
Check another faucet in the house to make sure
that household water pressure is adequate.
If the washer has been exposed to
temperatures below freezing for an extended
period of time, allow it to warm up before
pressingthe POWER button. Otherwise, the
display will not come on.
Make sure the inlet filters on the fill valves
are not clogged. Refer to the filter cleaning
instructions.
Check that inlet hoses are not kinked or
clogged.
This isan energy-efficient washer. As a result,
the temperature settings for this washer may be
different than non-energy-efficient washers.
Make sure that both hot and cold water faucets
are turned on all the way.
The washer will not operate if the lid is open.
Close the lid and make sure that nothing is
caught under the lid preventing it from closing
completely.
Check inlet hose connections. Make sure the hot
water supply is connected to the hot inlet valve,
and the cold water supply is connected to the
cold inlet valve.
This is a high efficiency washer. The water will
not normally cover the clothes. The fill level is
optimized for the wash motion to achieve the
best wash performance.
29