Publicidad
Idiomas disponibles
Idiomas disponibles
EN
Installation
UFO TYPE FISHEYE CAMERA INSTALLATION
Remove the front component by turning it anticlockwise. To fix the pedestal:
1. Drill the first fastening hole.
2. Pass the camera wire through the hole in the pedestal or alternatively in the side groove
according to the installation type.
3. Adjust the camera angle by turning the pedestal.
4. Drill the second and third hole, insert the three anchor bolts and fix the pedestal by
means of the three fastening screws.
5. Finally fix the camera body to the pedestal by turning it clockwise.
SD Card installation (UFO model fisheye only)
To insert the SD Card in the camera, remove the lid from the bottom of the camera by
undoing the two screws.
DS1093-575A
Fastenin
screw
SD card slot
Anchor
22
Publicidad
Capítulos
