Cisco 2800 Serie Guía Rápida página 33

Current interface summary
Controller Timeslots D-Channel Configurable modes Status
T1 0/0/0 24
T1 0/0/1 24
T1 0/2/0 24
T1 0/2/1 24
Any interface listed with OK? value "NO" does not have a valid configuration
Interface
GigabitEthernet0/0
GigabitEthernet0/1
GigabitEthernet0/3/0
Seleccione una de las interfaces disponibles para conectar el router con la red de gestión:
Paso 8
Enter interface name used to connect to the
management network from the above interface summary: fastethernet0/0
Responda a las solicitudes siguientes, de la manera más adecuada para su red:
Paso 9
Configuring interface FastEthernet0/0:
Use the 100 Base-TX (RJ-45) connector? [yes]: yes
Operate in full-duplex mode? [no]: no
Configure IP on this interface? [yes]: yes
IP address for this interface: 172.1.2.3
Subnet mask for this interface [255.255.0.0] : 255.255.0.0
Class B network is 172.1.0.0, 16 subnet bits; mask is /16
Paso 10 Se muestra la configuración:
The following configuration command script was created:
hostname Router
enable secret 5 $1$D5P6$PYx41/lQIASK.HcSbfO5q1
enable password xxxxxx
line vty 0 4
password xxxxxx
snmp-server community public
!
no ip routing
!
interface FastEthernet0/0
no shutdown
media-type 100BaseX
half-duplex
ip address 172.1.2.3 255.255.0.0
!
interface FastEthernet0/1
shutdown
no ip address
!
end
Paso 11 Responda a las solicitudes siguientes. Seleccione [2] para guardar la configuración inicial:
[0] Go to the IOS command prompt without saving this config.
[1] Return back to the setup without saving this config.
[2] Save this configuration to nvram and exit.
Enter your selection [2]: 2
Building configuration...
Use the enabled mode 'configure' command to modify this configuration.
23 pri/channelized
23 pri/channelized
23 pri/channelized
23 pri/channelized
IP-Address OK? Method Status
20.0.0.40 YES DHCP
unassigned NO
unassigned NO
Administratively up
Administratively up
Administratively up
Administratively up
up
unset up
unset up
Protocol
up
up
up
33