Inspection/Maintenance Schedule; Storage And Transport - 3M DBI-SALA 8560409 Manual De Instrucciones Para El Usuario

2.0 INSPECTION & MAINTENANCE
2.1 INSPECTION OF EQUIPMENT PRIOR TO USE:
• Check all structural parts for damage: dents, cracked welds bend or crushed tubes. Minor cosmetic damage will not
affect the structural integrity of the hoist, but any seriously damaged parts MUST BE repaired or replaced before
using the hoist.
• Check all hardware (pins, tri-screws, adjuster screws, nuts, bolts, pulleys, rollers and winch brackets) for damaged
threads, bend, damaged or missing fasteners, loose fasteners. Check all pulleys and rollers for chips, grooves and
excessive wear. Ensure that all pulleys and rollers turn freely.
• Inspect all equipment for missing, damaged or otherwise illegible warning labels (Figure 7). Any damaged, missing or
otherwise illegible labels MUST BE replaced before using hoist.
• If you are using 3M Fall Protection Winches with your hoist, inspect the winch and cable as outlined in the
"maintenance and inspection" section of the Digital Series Winch operators manual.
• Any additional winches, self-retracting lifelines (SRL's), work positioning or fall-arrest equipment being used with
your 3M Fall Protection Hoist MUST BE installed, inspected, maintained and operated according to the manufacture's
instructions.
• Report any problems with the equipment to your supervisor and DO NOT USE the equipment until it has been
repaired or replaced.
2.2

INSPECTION/MAINTENANCE SCHEDULE:

• DAILY ( BEFORE EACH USE): See above "Inspection of Equipment Prior to Use".
• WEEKLY: Perform a complete visual inspection of equipment as described in "Inspection of Equipment Prior to Use".
Clean equipment as required, to thoroughly inspect all welds, labels, pins, fasteners, pulleys, rollers, brackets and
parts. Record all findings in the the "Inspection & Maintenance Log" in this instruction. If any problems are found with
the equipment DO NOT USE until the equipment has been repaired.
;
Authorized Repairs Only: Only 3M or parties authorized in writing may make repairs to this equipment.
• ANNUALLY: Clean unit thoroughly, using a damp cloth and a mild soap solution. Perform a complete visual
inspection as described in "Inspection of Equipment Prior to Use" Record all findings in the "Inspection & Maintenance
Log." If any problems are found with the equipment, DO NOT USE until the equipment has been repaired.
2.3 STORAGE AND TRANSPORT: When not in use, store and transport the Pole Hoist System and associated equipment in
a cool, dry, clean environment out of direct sunlight. Avoid areas where chemical vapors may exist. Thoroughly inspect
components after extended storage. The Pole Hoist System should be stored indoors, or out of the elements if possible.
6