Mounting The Speaker - Harman JBL TOWER X MARINE SPEAKER Guia De Instalacion

DIMENSIONS
6.5"
8"

Mounting the speaker

1. Place the clamp around the horizontal bar of the tower.
2. Use the included M8 bolts to secure the clamp; insert the bolts from the top and turn clockwise with the included hex key
to tighten. For a secure fit, use the included rubber mats between the clamp and the bar.
3. Slide the speaker onto the clamp from below.
4. Secure the speaker onto the clamp using the included M6 bolt; insert the bolt into the hole at the back of the mounting
sleeve and turn clockwise with the included hex key to tighten.
NOTE: Be sure to align the bottom of the clamp with the hole through which speaker and LED wires pass into the wake
tower bar. Feed any remaining wire into the bar to prevent pinching.
EN
Swiveling the speaker
Loosen the mounting bolt. Swivel speaker to the desired angle (up to 360°). Tighten the bolt to secure in place.
11-1/16" (282.1mm)
14-5/16" (363.7mm)
Lorem ipsum
4
2
1
3
2