Model Hc-300 Description, Specifications And Standard Equipment Description; Specifications; Standard Equipment; Icons - RIDGID HC-450 Manual Del Operador

Chuck
GFCI
Arbor
Pilot Drill
Figure 1 – HC-450 with Standard Equipment
Model HC-300 Description,
Specifications And Standard
Equipment
Description
The RIDGID ® Model HC-300 Hole Cutting Tool is de-
signed to cut holes up to 3" diameter into steel pipe. The
multiple hole size allows the use of Mechanical T's
Hookers ® , Vic-O-Lets™, Weld-O-Let™ and other fittings
for branching unpressurized pipelines.
The HC-300 features a 1 /
2
date all size of holes up to 3" diameter and standard
hole saw arbors up to 7 / " Hex (
16
motor and gear reduction optimizes the performance
and saw life in the capacity range. A single feed handle
and ON/OFF switch allows for easy operation. The com-
pact two-piece design allows the HC-300 to be used in
tight quarters and difficult-to-reach locations.
NOTE! Mechanical T's, Hookers, and Vic-O-Lets are
registered trademarks of Victaulic Tool Company.
Feed
Handle
Chuck
GFCI
Chuck Key
Figure 2 – Model HC-300 with Standard Equipment
ON/OFF Switch
Gib Screw
Feed
Handle
Swivel
Handle
Chain
Chuck Key
" capacity chuck to accommo-
1 / " chuck size). An integral
2
ON/OFF
Switch
Warning
Label
Crank Screw
Assembly
Chain
HC-450/HC-300 Hole Cutting Tools

Specifications

Cutting Capacity ............Up to 3" (76mm)
Pipe Mounting
Capacity ........................1
Drill Chuck Capacity ......
Drill Chuck Speed..........360 RPM
Motor Horsepower.........1.2 HP
Current Draw Rating......11 Amps @ 115V
Dimensions
Height ............................12.8" (32.5 cm)
Length ...........................11.9" (30.2 cm)
Width .............................13.2" (33.4 cm)
Total Weight ..................31 lbs. (14 kg)
Base ...........................10 lbs. (4.5 kg)
Motor Assembly..........21 lbs. (9.5 kg)

Standard Equipment

• Hole Cutting Tool (Base and Motor Assembly)
® ,
• Chuck Key
Figure 3 – Machine Serial Number
For both the HC-450 and HC-300 Hole Cutter Tool, the
serial number is located on the underside of the motor.
The last 4 digits indicates the month and year of the
manufacture. (03 = month, 10 = year).

Icons

Power ON
Power OFF
Selection of appropriate materials and instal-
NOTICE
lation, joining and forming methods is the responsibility of
the system designer and/or installer. Selection of im-
proper materials and methods could cause system failure.
Stainless steel and other corrosion resistant materials
can be contaminated during installation, joining and form-
ing. This contamination could cause corrosion and pre-
1 / " - 8" (30mm-200mm)
4
1 / " - 1 / " (2mm-13mm)
16 2
5.5 Amps @ 230V
12 Amps @ 100V
Date Code
5