Operating (Controls); Heater Operation; General; Controls Operation - Pentair Water MiniMax 75 Manual De Operación Y Instalacion

8

OPERATING (CONTROLS)

DIRECT SPARK ELECTRONIC AND
MILLIVOLT MODELS
For convenience and economy all MiniMax 100
heaters are equipped with a thermostat on the front of
the heater control panel; see Figure 3.
Direct Spark MiniMax 100 heaters are equipped
with an electronic thermostat while Millivolt MiniMax
100 heaters have a mechanical thermostat.
The Pool/Off/Spa switch allows the heater to be turned
off when heating is not desired.
1. "ON" position - Maintains selected pool temperature.
2. "OFF" position - Heater will not come on regardless
of drop in pool temperature.
THERMOSTAT ADJUSTMENT
The knob with locking feature eliminates the need for
constant thermostat adjustments. Set the knob pointer
to the desired spa temperature.
NOTE
To eliminate error due to piping heat losses
measure pool temperature with an accurate
thermometer directly at the pool or spa.
If further adjustment is needed rotate the knob until the
desired temperature is obtained. This knob position
corresponding to your desired maximum pool or spa
temperature may now be preset (locked) by the knob
stopper which prevents the knob from being turned
beyond the maximum temperature you set.
THERMOSTAT KNOB STOPPER
Each thermostat is equipped with a mechanical stop
that can be locked or unlocked with use of a screw-
driver to prevent temperatures in excess of that
desired by the user; see Figure 3.
The maximum setting can be adjusted by loosening
the screw "A" and turning the stopper dial to desired
maximum setting. Lock the setting by tightening the
screw. The Mechanical stop is under the knob.
Ensure that the knob is stopping at the correct posi-
tion when the knob is rotated clockwise from a lower
temperature position.
P/N 471105

HEATER OPERATION

GENERAL

The MiniMax 100 DSI employs a microprocessor
based Direct Spark Ignition (DSI) system to light the
main burner and therefore has no pilot. The ignition
circuit operates at 24 VAC and requires that line
voltage 115/230 be supplied to the heater.
The MiniMax 100 MV (Millivolt) requires no external
power source and the control circuit derives all its
power from the energy generated from the standing
pilot/ thermopile-generator combination. Note: Some
states ,including California, have energy conservation
regulations preventing the sale and use of certain
standing pilot (millivolt) equipment.
The MiniMax 100 DSI Control utilizes a
microprocessor to continually and safely monitor,
analyze, and control the proper operation of the gas
burner. The DSI Control features LED diagnostics,
automatic one hour reset, and flame current test pins.
The LED is located on the DSI.

CONTROLS OPERATION

Heat Mode
1. When a call for heat is received from the thermostat
supplying 24 volts to TH terminal on control, the
control will reset, perform a self check routine, and
flash the diagnostic LED for up to four seconds.
After a brief delay the gas valve is energized and
the ignition electrode begins to spark for the four
(4) second trial for ignition (TFI) period.
2. When flame is detected during the trial for ignition,
sparking is shut-off immediately and the gas valve
remains energized. The thermostat and main burner
flame are constantly monitored to assure the system
continues to operate properly.
a. When the thermostat is satisfied and the demand
for heat ends, the main valve is de-energized
immediately.
Knob Stopper
Operation (contd.)
(DSI SYSTEM)
Figure 3.
Screw A
Rev. H 10-16-07