Adjust The Door - Kenmore 595.68045 800 Serie Manual De Uso Y Cuidado

Refrigerador con congelador en la parte inferior
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

A slust
{}oos
Depending on your model, your refrigerator may have two front
adjustable rollers (Style 1) or four adjustable rollers (Style 2)
located at the base of the refrigerator. If your refrigerator seems
unsteady or you want the door to close more easily, use the
instructions
below.
Stylel-Freezer
Door Models
1. Remove the base grille. Grasp the grille firmly and pull it
toward you.
2. Remove the bracket cover. Insert the eraser end of a pencil in
the cover notch. Apply slight downward
pressure to the
notched side of the cover while swinging it off.
3. Using a screwdriver or 3/8"hex driver, turn the roller
adjustment screw on each side to raise or lower that side of
the refrigerator.
NOTE: Having someone push against the top of the
refrigerator takes some weight off the adjustment screws and
rollers. This makes it easier to turn the screws It may take
several turns of the roller adjustment screw to adjust the tilt of
the refrigerator.
To raise, turn the roller adjustment screw to the right.
To lower, turn the roller adjustment screw to the left.
4. Turn the brake foot clockwise until it is firmly against the floor
to keep the refrigerator from rolling forward when the freezer
drawer is pulled open.
Style 2-Freezer
Drawer Models
1. Remove the base grille. Grasp the grille firmly and pull it
toward you.
2. Raise or lower the cabinet. Using a 3/8"hex driver, turn the
roller adjustment screw(s) on each side to raise or lower that
side of the refrigerator.
NOTE: Having someone push against the top of the
refrigerator takes some weight off the adjustment screws and
rollers. This makes it easier to turn the screws. It may take
several turns of the roller adjustment screw to adjust the tilt of
the refrigerator.
To raise, turn the roller adjustment screw to the right.
To lower, turn the roller adjustment screw to the left.
3. Turn the brake foot clockwise until it is firmly against the floor
to keep the refrigerator from rolling forward when the freezer
drawer is pulled open.
A
A. Rear roller adjustment
screw
B. Front roller adjustment
screw
C. Brake foot
NOTE: Your refrigerator may have a rear roller adjustment
screw on each side. To raise or lower the rear of the
refrigerator, use a 3/8"hex driver to turn the screws.
4. Open the door again to make sure that it closes as easily as
you like. If not, tilt the refrigerator slightly more to the rear by
turning both leveling screws clockwise.
It may take several
more turns, and you should turn both screws the same
amount.
5. Replace the base grille.
A. Roller adjustment screw
B. Brake foot
5. Open the door again to make sure that it closes as easily as
you like. If not, tilt the refrigerator slightly more to the rear by
turning both roller adjustment screws to the right. It may take
several more turns, and you should turn both adjustment
screws the same amount.
6. Replace the bracket cover. Place the bracket cover into the
outer edge, swing the cover toward the cabinet and snap it
into place.
7. Replace the base grille.
11

Publicidad

Capítulos

Tabla de contenido

Solución de problemas

loading

Tabla de contenido