Freezer Features; Ice Service Rack; Freezer Door Shelf; Door Features - Kenmore 595.68045 800 Serie Manual De Uso Y Cuidado

Meat Storage Guide
Store most meat in original wrapping as long as it is airtight and
moisture-proof. Rewrap if necessary. See the following chart for
storage times. When storing meat longer than the times given,
freeze the meat.
Fresh fish or shellfish ......................... use same day as purchased
Chicken, ground beef, variety meats (liver) ...................... 1-2 days
Cold cuts, steaks/roasts ................................................... 3-5 days
Cured meats ................................................................... 7-10 days
Leftovers - Cover leftovers with plastic wrap, aluminum foil, or
plastic containers with tight lids.
DOOR FEATURES
Your model may have some or all of these features.
©ap/Cente
To remove and replace the dairy center:
1. Remove the dairy center by raising and holding the cover up
while lifting the dairy center up and pulling it straight out.
2. Replace the dairy center by sliding it in above the desired
support and pushing it down until it stops.
FREEZER FEATURES
Your model may have some or all of these features.
The ice service rack holds an ice cube tray.
To install and remove the ice rack:
1. Install the ice rack by sliding the L-shaped groove in the side
of the shelf onto the wall screw. Push the rack toward the
back. Then, lower the front of the rack onto the front screw.
2. Remove the ice rack by lifting the front of the rack from the
front wall screw. Then, pull the rack forward and lift up to
unhook it from the rear wall screw.
F s,eze Dos St e f
Convenient storage for smaller frozen food items.
To remove and replace the shelf:
1. Remove the shelf by sliding it up and pulling it straight out.
2. Replace the shelf by sliding it in above the desired support
and pushing it down until it stops.
To remove and replace the bins:
1. Remove the bin by lifting it up and pulling it straight out.
2. Replace the bin by sliding it in above the desired support and
pushing it down until it stops.
©eeD t,,,,O£
o ;,.......... Ooo_" Buck¢3:
© bO s@
Provides easy access to items stored in the door.
To remove and replace the door bucket:
1. Remove the door bucket by tilting it and pulling it straight out.
2. Replace the door bucket by tilting the front down slightly, to
slide it into the bracket and tip upright.
To move the door bucket frame:
1. Remove the bucket.
2. Lift the frame up and pull it straight out.
3. Slide the frame in and down into the new location.
14