Daikin R410A SPLIT Serie Manual De Instalación página 12

Mounting Installation Plate
Ensure that the wall is strong enough to withstand the weight
of the unit. Otherwise, it is necessary to reinforce the wall
with plates, beams or pillars.
Use the level gauge for horizontal mounting, and fix it with 5
suitable screws for FTXB/FTKB 09/12 and 7 suitable screws
for FTXB/FTKB 18/24.
In case the rear piping draws out, drill a hole 2-9/16" (65mm)
in diameter with a cone drill, slightly lower on the outside
wall (see figure).
FTXB/FTKB 09/12
Mounting plate
fixing screw
FTXB/FTKB 18/24
Mounting plate
fixing screw
Drilling a Wall Hole and Installing Wall Embedded
Pipe
Hole With Cone Drill
Inside
Wall embedded pipe
(Field supply)
Wall hole cover
(Field supply)
Mounting plate
Mounting plate
Outside
Caulking
Ø 2-9/16" (65mm)
Wall embedded pipe
(Field supply)
Mount The Unit Onto The Installation Plate
Hook the indoor unit onto the upper portion of the installation
plate (Engage the two hooks at the rear top of the indoor unit
with the upper edge of the installation plate). Ensure that the
hooks are properly seated on the installation plate by moving
it to the left and right.
How To Attach The Indoor Unit
Hook the claws of the bottom frame to the mounting plate.
How To Remove The Indoor Unit
Push up the marked area (at the lower part of the front
grille) to release the claws.
Front grille
Hand indoor unit's hook here.
When stripping the ends
of interconnecting wires in
advance, bind right ends of
wires with insulating tape.
Water Drainage Piping
The indoor drain pipe must be in a downward gradient for
smooth drainage. Avoid situations that are likely to cause
water to leak.
Water Drainage
Water
leaking
Correct Wrong
! CAUTION
• Do not install the unit at altitude over 6560ft (2000m)
for both indoor & outdoor.
1-10
Mounting plate
Clip
Bottom frame
Mark (Rear side)
Mounting plate
Interconnecting
wires
Wire guide
Water
retention
Water Water
leaking leaking
Wrong Wrong
End
dipped
into
water
Drain