Publicidad
Idiomas disponibles
Idiomas disponibles
Read these instructions and this manual in
its entirety before you attempt to assemble
or operate your new trimmer.
IMPORTANT: T his trimmeris shippedWITH-
OUT OIL OR GASOLINE in the engine.
Your new trimmer has been assembled
at the factory with the exception of those
parts left unassembledfor shipping
purposes. All parts such as nuts, wash-
ers, bolts, etc., necessary to complete the
assembly have been placed in the parts
bag. Toensure safe and proper operation
of your trimmer, all parts and hardware
you assemble must be tightened securely.
Use the correct tools as necessaryto
ensure proper tightness.
When right hand (RH) or left hand (LH)is
mentioned in this manual, it meanswhen
you are in the operating position (standing
behind the handle).
Loose Parts Packed Separately
\\\\
\\\\
handle
LIFT UP
Handle
knob
Lower
handle
[
Bottle of oil
Trimmer
Lines (2) Sets
(0.155 diameter
x 18,75 inches long)
REMOVE
TRIMMER
FROM
CARTON
1. Remove loose parts included with trimmer.
2. Cut down two end corners of carton
and lay end panel down flat.
3. Remove all packing materials.
4. Roll trimmer out of carton and check car-
ton thoroughly for additional loose parts.
HOW
TO SET
UP YOUR
TRIMMER
TO UNFOLD
HANDLE
IMPORTANT:
Unfold handle carefully so
as not to pinch or damage control cables.
1. Loosen handle knob enough to allow
upper handle to be unfolded from the
shipping position.
2. Raise upper handle section into place on
lower handle and tighten handle knob.
3. Remove handle padding holding trim-
mer head control bar to upper handle.
Your trimmer handle can be adjusted for
your trimming comfort.
Refer to "ADJUST
HANDLE" in the Service and Adjustments
section of this manual.
INSTALL
STARTER
ROPE
1. Loosen T-knob.
2. Place throttle control in FAST position.
3. Slowly pull engine starter rope out until
rope will slip into loop of rope guide.
4. Tighten T-knob.
Rope g
ob
6
Engine
rope
Publicidad
