Publicidad
Idiomas disponibles
Idiomas disponibles
SAFETY GLASSES
The operation of any trimmer can result in foreign objects being thrown
into the eyes, which can result in severe eye damage.
Always wear safety glasses or eye shields while operating your trimmer
or performing any adjustments
or repairs.
We recommend
standard
safety glasses or a wide vision safety mask worn over spectacles.
HOW
TO USE YOUR
TRIMMER
ENGINE SPEED
The engine speed is controlled
by a throt-
tle located on the side of the upper handle.
FAST position is for starting and normal
trimming.
SLOW is for light trimming
and
fuel economy.
STOP is for stopping the
engine.
@
/
\'--L
/'_'\
/P--I
I
//
//
TRIMMER
HEAD DRIVE CONTROL
Your trimmer is equipped with a trimmer
head drive control bar which will require
the operator to be positioned behind the
trimmer handle to operate the trimmer.
• To start trimmer head rotation, push the
trimmer head control lever (1) forward
and hold the trimmer head control bar
down to the handle (2).
• To stop trimmer head rotation, release
the trimmer head control bar.
Trimmer head
control lever
Trimmer head
control bar
\
\
'\\\\i
\
\\
TO ENGAGE
TRIMMER HEAD
TO ADJUST TRIMMING
HEIGHT
ACAUTION:
Stop the engine and wait
for all moving parts to stop. Disconnect
spark plug wire from spark plug and place
wire where it cannot come in contact with
plug.
The height of cut can be set to six (6) dif-
ferent positions ranging from 1-1/2 inches
to 3 inches. Recommended
cutting height
for the average yard is 2 inches.
1. To adjust trimming height, push in the
locking plate tab and move trimmer
head up or down to desired position.
2. Release tab and be sure head is
locked into one of the six (6) height
posit_
Adj
Trimmer
Head
Locking
Plate Tab
1
BEFORE
STARTING
ENGINE
ADD OiL
Your trimmer is shipped without oil in the
engine. For type and grade of oil to use,
see "ENGINE"
in the Maintenance
section
of this manual.
A CAUTION:
DO NOT overfill engine with
oil, or it will smoke on startup.
1. Be sure trimmer is level and area
around oil fill is clean.
2. Remove oil dipstick from oil fill spout.
Make sure that rim of spout is clean.
3. You receive a container of oil with the
unit. Slowly pour the entire container
down the oil fill spout into the engine.
NOTE: Initial oil fill requires only 18 oz.
due to residual oil in engine from the
manufacturers
100% quality testing. When
8 changing oil you may need 20 oz.
Publicidad
