Denon DJ X1800 Prime Guia Del Usuario página 14

FX List Customize: Use this screen to customize the order of effects. Turn the FX
o
Select/Enter knob to select an effect from the list of available ones on the left side,
and then press the knob to add the effect to the new order on the right side. Repeat
this step for each effect, or select -Cancel- to return to the previous screen. After
you have done this for all effects, select -End- to save your customized list.
BPM FX On Color: This setting determines the color of the FX On/Off button while it
o
flashes: red, spring green, green, light blue, blue, yellow, orange, or purple.
System
These settings determine overall operation.
•
Info: These screens contain information about the current firmware version and network
information.
Version: This is the current X1800 Prime firmware version.
o
IP Address: This is the IP address that X1800 Prime is using.
o
MAC Address: This is the MAC address that X1800 Prime is using.
o
•
Engine Connect: Select Auto to enable X1800 Prime to automatically receive timing and
BPM information (to synchronize effect tempos) from SC5000 Prime units connected to
its Link ports and to send track and user profile data between them. X1800 Prime will
also automatically detect and configure each SC5000 Prime once you connect their Link
ports. Select Manual to disable automatic linking and only activate this feature manually
by pressing and holding the Engine Connect button until the Channel Assignment
screen appears on the SC5000 Prime units. You can then freely assign each SC5000
Prime layer to a specific channel.
•
Cue Settings:
Cue Solo Mode: Select On to use the Channel Cue buttons as "solo" buttons
o
(pressing one will mute all other channels). Select Off to use them as normal cue
buttons (pressing one will send its signal to the cue channel).
Cue 1–4 Color: This setting determines the color of the Cue buttons for each
o
channel: red, spring green, green, light blue, blue, yellow, orange, or purple.
Reset Cue Defaults: Select OK to return the Cue settings to their default values, or
o
select Cancel to return to the previous menu.
•
Network Settings:
Refresh IP Address: Select OK to renew your IP address, which reestablishes the
o
connection between your X1800 Prime and any SC5000 Prime units connected to
the Link ports. Select Cancel to return to the previous screen.
•
MIDI: These are MIDI settings that determine the MIDI channels and connections used.
Clock Send: These settings determine whether or not X1800 Prime will send MIDI
o
Clock messages over each of these connections. For each option, select On to
enable transmission or Off to disable it.

USB: This applies to both USB Ports 1 and 2. If you are using X1800 Prime to
control software, set this to On.

5pin: This applies to the MIDI out.
Active Send: These settings determine whether or not X1800 Prime will send normal
o
MIDI messages over each of these connections. For each option, select On to
enable transmission or Off to disable it.

USB: This applies to both USB Ports 1 and 2. If you are using X1800 Prime to
control software, set this to On.

5pin: This applies to the MIDI out.
•
Factory Reset: Select OK to restore X1800 Prime to its factory default settings (wait a
few seconds after selecting this before resuming normal operation). Select Cancel to
return to the previous screen.
14