3M Filtrete -30 Guia De Instalacion

Install Guide 3M-30
Caution
• Your thermostat is a precise instrument, handle it with care.
• Turn off electricity to the HVAC system before installing or
servicing thermostat or any part of the system.
• Do not turn electricity back on until work is completed.
• Do not short (jumper) across electric terminals at the control
on the furnace or air conditioner to test the system. This may
damage the thermostat.
• All wiring must conform to local codes and ordinances.
• This thermostat is designed for use with 3AA alkaline batteries
and/or 24 volt AC C wire (or a 12-24 AC or DC source) and
millivolt gas systems. Each thermostat relay load should be
limited to 1.0 amp; higher amperage may cause damage to the
thermostat.
Caution
to prevent damage to the furnace, air conditioner, and
disconnect the power supply
thermostat,
beginning work. This can be done at the circuit breaker.
1005-001-001
To avoid electrical shock and
before
top cover
Reset
button
HVAC
selections
switches
Save
Energy
button
PM
Power Grid
RAD IO
status
indicator
1
LINK
TAR GET TEM P
bottom
cover
Wire
terminals
Mode
DAY
AUT O
button
F
Fan
button
CO OL
MENU
butto
PROG
butto n
Touch screen
ENGLISH
1
PG
n