Congratulations, you have successfully installed your unit. Please proceed to
the OPERATING Guide to initialize the 3M-30.
IMPORTANT: After you have labeled and connected your
wires, followed the correct HVAC setup, and your system
does not operate, contact support at filtrete@radiothermostat.com
or 888-607-5824 8am-midnight EST.
STATEMENT OF USE: This thermostat can be used with
3AA batteries, 24VAC (C wire), 24VAC adapter, heating and
cooling systems and also millivolt heating. It cannot be used
with line voltage systems. This thermostat is digital and your
desired heat or cool temperatures can easily be set on the
large touch screen with the +/- buttons. A minimum 4 minute
off time protects the compressor from damage.
This thermostat runs on 3AA batteries. It can also run on
the HVAC systems 24VAC (C wire) or external 24VAC
transformer connected to the C and RH terminals. The
24VAC (C wire) is the other side of the 24VAC heating transformer and can be found where the other
thermostat wires connect at the wall or at the furnace. Do not use the common or ground side of the
line voltage.
still
PM
RAD IO
1
LIN K
TAR GET TEM P
PG
PG
MODE
control
DAY
AUT O
F
CO OL
FAN
control
12
12