Remedying Possible Malfunctions - Hilti GX 3 Manual De Instrucciones

4. Close the magazine locking catch.
8.4 Removing the fastener guide
1. Remove the gas can. → page 8
2. Move the fastener guide release slider to the EJECT position.
3. Remove the fastener guide.
8.5 Inserting the fastener guide
1. Remove the gas can. → page 8
2. Slide the fastener guide into the slot in the nose of the fastening tool.
3. Hold the fastener guide securely so that it cannot fall out and then press the nose of the tool (i.e. the tool
with the fastener guide) against a firm surface until the fastener guide engages.
4. Check that the fastener guide has engaged.
◁ Once the fastener guide has engaged, the slider for releasing the fastener guide is again in the +
position.
8.6 Removing the support leg
1. Release the support leg engaging mechanism by pressing lightly.
2. Rotate the support leg through 90°.
3. Remove the support leg.
8.7 Fitting the support leg
1. Bring the support leg into contact with the magazine at right angles and guide it into the slot.
2. Rotate the support leg through 90° relative to the magazine and allow it to engage while applying light
pressure.
8.8 Inserting the single-fastener adapter
1. Remove the gas can. → page 8
2. Remove the magazine. → page 8
3. Insert the single-fastener adapter.
4. Fit the magazine. → page 8
8.9 Removing the single-fastener adapter
1. Remove the gas can. → page 8
2. Remove the magazine. → page 8
3. Remove the single-fastener adapter.
4. Fit the magazine. → page 8

9 Remedying possible malfunctions

9.1 Remedying an incorrect piston position
▶ Check the position of the RESET → page 4 button.
Result
• RESET button projects from the tool casing. Its white edge is visible.
To remedy the incorrect piston position, press the RESET button.
9.2 Removing foreign objects and nails from the area around the fastener guide
CAUTION
Risk of injury by flying parts! Triggering the tool (attempting to drive a fastener) when foreign objects
are present in the area around the fastener guide, or when a fastener is jammed in the fastener guide,
may lead to injury caused by flying objects or fragments.
▶ Never attempt to remedy tool malfunctions by continuing to trigger the tool!
1. Remove the gas can. → page 8
2. Unload the magazine. → page 8
9