Dvdpak Settings - RIDGID SeeSnake DVDPak OLED Manual De Instrucciones

DVDPak Settings

The following settings may need to be checked or modi-
fied depending on where and how you are using the
DVDPak.
Video Display Setting
If you do not see the camera view in the display, you
may need to do the following (Figure 9):
1. Press the Return button
DVDPak control pad. A menu will appear.
2. Using the Arrow Buttons
DVD option and press the Enter button.
3. Using the Arrow Buttons
option and press the Enter button.
These steps inform the unit of the correct source for dis-
play.
Auto-Chapter Setting
The Auto-Chapter setting will serve best if it is set to
"Off", meaning that the recorder will start a new chapter
each time you pause the recording. To do this, press the
Return Button to access the Main Menu and select
"Setup". Arrow down to Auto-Chapter and press Enter
. Toggle the setting to "Off" using the Arrow Buttons
and press Enter .
NTSC/PAL Video Setting
It may be necessary to set your recorder to format discs
to the same color format as the camera is sending it. The
Color System options are NTSC (U.S.) or PAL (Europe).
The unit will not record if the color system conflicts with
the disc format. To set the Color System option:
1. Press the Return button
2. Press the Arrows
Enter to bring up the Setup Menu.
3. Arrow down to Color System and press Enter.
4. Use the Arrow Buttons
color system (NTSC for U.S. and PAL for Europe, for
example).
5. Press Return to go up to the Main Menu, and repeat
steps 2 and 3 of Video Display Setting (on page 9).
The setting that is in place in the setup menu at the
time of formatting the disc determines the discʼs for-
mat. You can display either PAL or NTSC input on the
DVDPak, regardless of how the "Color System" is set
in the Sony Unit. However, after you have formatted a
DVD, you can only record in the color system that
was in effect when the disc was formatted.
on the left side of the
highlight the Video
highlight the VIDEO IN
to access the main menu.
to highlight Setup and press
to highlight the correct
Ridge Tool Company
SeeSnake
Units Setting
The DVDPak can be set to display distance in meters or
feet, or to allow the setting to be selected automati-
cally. (This applies to SeeSnake systems equipped with
CountPlus digital distance counters only.) To set the
unit option:
1. With the DVDPak powered on, press the Menu Key
.
2. Use the Arrow Keys
3. Use the Select Key
or Auto.
4. When the choice you prefer is highlighted, simply
press the Menu Key
Color Setting
The DVDPak display can be adjusted for greater color
density in the display. To adjust the color:
1. With the DVDPak powered on and connected to a
See Snake camera, press the Menu Key
2. If the Color option is not highlighted on the Menu, use
the Arrow Keys
3. Use the Arrow Keys
preference.
4. When the display suits your requirements, simply
press the Menu Key
Contrast and Brightness Setting
Use the same steps shown under Color Setup to adjust
the Contrast and Brightness settings of the display.
Note that you may want to adjust these again during the
inspection depending on light and color conditions inside
the pipe. You can also access the Brightness control di-
rectly simply by pressing the Brightness Key
®
DVDPak
to scroll down to Unit.
to move from Feet to Meters
again to close the menu.
.
to scroll to the Color option.
to adjust the color to your
again to close the menu.
.
9