Operating Instructions; Starting Up; Inspecting The Line; Brightness Adjustment - RIDGID SeeSnake DVDPak OLED Manual De Instrucciones

Operating Instructions

WARNING
Always wear eye protection to protect your eyes
against dirt and other foreign objects.
When inspecting drains that might contain haz-
ardous chemicals or bacteria, wear appropriate
protective equipment, such as latex gloves, goggles,
face shields or respirators, to prevent burns and in-
fections.
Do not operate this equipment if operator or ma-
chine is standing in water. Operating machine while
in water increases the risk of electrical shock.
Rubber soled, non-slip shoes can help prevent slip-
ping and electric shock, especially on wet sur-
faces.
Follow operating instructions to reduce the risk of
injury from electrical shock and other causes.
1. Check the unit is properly set up.

Starting Up

2. Connect the DVDPak either to the SeeSnake camera
directly or to an external SeeSnake monitor using the
RCA cable.
3. Place the camera head into the reelʼs guide hoop and
turn the DVDPakʼs power on
4. If there is a disc in the DVD tray, the system will do a
disc check. It will ask for a disc if none is found.
5. To insert a disc, press the Eject button
a blank DVD-R or DVD-RW into the tray. Close the
tray by pressing the Eject Button.
Make sure the plug seal is opened before
ejecting the disc tray. This will avoid damaging the
NOTICE
tray mechanism.
6. If the system finds an unformatted disc it will ask
permission to format it. Press RETURN
The unit will not record to an unformatted disc.
7. Close the DVDPak disc tray front plug seal to protect
against dust and moisture.
.
and insert
to format.
Ridge Tool Company
SeeSnake
Figure 11 – DVD Tray Open
Once a formatted disc is detected, the camera view
should appear on both the DVDR screen and the DVDPak
monitor. If you do not see the camera view on the display,
the source for the display needs to be changed. (See
Video Display Settings on page 9.)
Figure 12 – Camera Image Display On DVDR Screen
1. Power up the DVDPak if it is off.

Inspecting The Line

2. Put the camera head in the line.
3. Proceed with pipe inspection as described in your
SeeSnake manual.

Brightness Adjustment

You may find you need to increase or decrease the
camera LED brightness while inspecting the inside of a
® DVDPak
11