JBS Advanced Serie Manual Del Usuario página 5

Temperature decrease
SETUP mode
selection
Vacuum pump
selection
Suction selector
for tripods and
extractors
OPERATION
Description of controls
- BUTTONS:
HEAT. Activates or deactivates the air flow. The HEAT HEAT HEAT HEAT
hot-air flow automatically turns off after the
selected time.
SUCTION SUCTION. On/off switch for the self-contained SUCTION
SUCTION SUCTION
suction pump.
KEYS KEYS KEYS KEYS KEYS and
temperature of the handpiece. This enables
temperatures from 150 to 450°C (300 to 840°F)
to be selected.
The selected temperatures are reference values
which may change depending on the distance
between the heating element and the nozzle.
The display shows the actual air temperature
when the unit is working measured at a distance
of 10mm from the nozzle.
SELECT. It allows the access to the SETUP SELECT SELECT
SELECT SELECT
mode of the station.
Temperature increase
. Decrease or increase the
Heating element ON-OFF switch
- CONTROLS:
This enables the air flow to be set on a scale
from 1 (corresponding to the lowest setting of
6 l/min) to 10 (corresponding to the highest of
45 l/min).
- PEDAL:
Hot air is produced when it is held down.
Releasing it the heater is disconnected,
though the turbine continues to operate until
the air temperature falls below 100°C (212°F)
Pedal
Ref. 0964551
3
ENGLISH
Air flow
regulation
Heater inlet
AIR FLOW