JBS Advanced Serie Manual Del Usuario página 9

- Place the extractor and press the suction cup
until it sticks onto the component.
- Use the pedal or the HEAT button to start the
self-contained hot-air pump, directing it with a
circular movement at the component terminals
and taking care to distribute the heat evenly.
- When the soldering flux turns liquid the
extractor will automatically lift the component.
There are different models of protectors and
extractors as accessories.
The measurements of all the extractors and
protectors are given on page 56 of instructions
manual.
C) Tripod:
For small components for which an extractor
cannot be used, we recommend use of 20 tripod
Ref. 0932050, as shown in the figure.
Use the 40 tripod Ref. 0932250 for larger integrated
circuits.
SOLDERING PROCEDURE
1 After desoldering the component, any solder
left on the printed circuit should be removed
using a desoldering station. We recommend
our DD 5700 sold / desold kit.
7
ENGLISH