Black and Decker LSW20 Manual De Instrucciones página 135

Ocultar thumbs Ver también para LSW20:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

REPlACiNG thE SPOOl (FiGuRES 12,13,14)
• Remove battery from tool.
• Depress the tabs (k) and
remove the spool cap (l) from
the spool housing (m) in the
trimmer head (figure 12).
• For best results, replace
spool with Black & Decker
model # AF-100.
• Grasp empty spool with one
hand and spool housing with
other hand and pull spool out.
• If lever (n) (figure 13) in
base of housing becomes
dislodged, replace in correct
position before inserting new
spool into housing.
• Remove any dirt and grass
from the spool and housing.
• Unfasten the end of the
cutting line and guide the line
into the eyelet (o) figure 14.
• Take the new spool and
push it onto the boss (p)
(figure 13) in the housing.
Rotate the spool slightly until it
is seated.
The line should protrude
approximately 5-3/8 inches
(136mm) from the housing.
12
Replacement
spool
Model #
AF-100
k
13
n
• Align the tabs on the spool
cap with the slots (q) in the
housing (figure 14).
• Push the cap onto the
housing until it snaps
l
securely into place.
CAutiON:
To avoid
tool damage, if the cutting
line protrudes beyond the
trimming blade, cut it off so that it just reaches the blade.
REWiNDiNG SPOOl FROM BulK liNE
k
(uSE ONlY .065 iN. ROuND DiAMEtER liNE) (FiGuRES 15, 16, 17)
Bulk line is also available for purchase from your local retailer.
NOtE: Hand wound spools from bulk line are likely to become
m
tangled more frequently than Black & Decker factory wound
spools. For best results, factory wound spools are recommended.
To install bulk line, follow the steps below:
• Remove battery from tool.
• Remove the empty spool
from the tool as described in
"REPlACiNG thE SPOOl".
• Remove any remaining
cutting line from the spool.
p
• Make a fold at the end of
the cutting line at about 3/4
inch (19mm)(r). Feed the
cutting line into one of the
line anchoring slots (s) as
shown in figure 15.
11
14
q
15
s
o
r

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido