Evaporative Wick - Aircare 826000 Guía De Uso Y Cuidado

NOTES ON LOCATION
In order to get the most effective use from your humidifier, it is important to
position the unit where the most humidity is needed or where the moist air will be
circulated throughout the house such as near a cold air return. If the unit is
positioned close to a window, condensation may form on the window pane. If this
occurs the unit should be repositioned in another location.
Do NOT position the unit directly in front of a hot air duct or radiator. Do NOT
place on soft carpet.
Due to release of cool, moist air from the humidifier, it is best to direct air away
from thermostat and hot air registers. Position humidifier next to an inside wall on
a level place at least 4 inches away from the wall or curtains.
ASSEMBLY
1) Unpack humidifier from carton.
2) Remove all packaging materials. Check to see that you have all of the
following items removed from the box, accessory kit and cabinet before
discarding the packaging:

Evaporative wick and wick retainer

Lift Rod assembly with Styrofoam float
CASTERS
3) Turn the emptied cabinet upside down. Insert each caster stem into one of
the four caster holes on the corner of the humidifier bottom. The casters
should fit snugly and be inserted until the stem shoulder reaches the cabinet
surface.
4) Turn the cabinet right side up.

EVAPORATIVE WICK

5) Place the float assembly and
attached lift rod into the boxed
area on the bottom of the
inside of the cabinet. Slip lift
rod into retainer ring and twist
to secure. The lift rod should
be able to freely move up and
down about 3/8". The retainer
ring should be located between
the two ribs on the lift rod.
6) Place the wick assembly into
the guides provided in the
bottom of the cabinet and the
ribs along the sides.
7) Place the chassis unit onto the
cabinet ensuring that the
chassis seats correctly into the
front and back grooved edges.
:
4

Caster kit

Manual