Petsafe Aqua Fountain Cube Manual De Instrucciones página 13

4. Next, feed the electrical power cord through the bottom of the Bowl until there
is no slack left. Press the cord into the Cord Channel and feed through the Cord
Notch on either side on back of the Bowl. Fit Rubber Gasket in place (Fig. 20).
Fig. 19
Cord-Pass-Through
5. Turn the Housing over and insert the Foam Filter on the side of the Housing with
the water grate (Fig. 21).
6. Attach the Housing to the Bowl. Push Housing down firmly until the locking tabs
snap into place.
7. Replace your Charcoal Filter. Make sure the black side is facing out toward the
Bowl (Fig. 22).
Fig. 21
8. Place the Pet Fountain in a desired location. Do not pick up a full Pet Fountain by
the Housing. To properly pick up the Pet Fountain, use both hands and grip the
sidewalls of the Bowl and lift up. To protect your floor always use a protective mat
such as a towel or water-resistant placemat. This will help protect your floor from
any splashing or spills caused by your pet.
9. Fill the Pet Fountain by pouring water directly into the Bowl and the Housing.
Leave at least a 6 mm to 12 mm of space between the water level and the rim of
the Bowl to help control spills and splashing. Attach the Housing Lid.
10. Make sure your hands and the electrical power cord are dry. Connect the In-Line
Plug to the Adaptor and Plug into an standard electrical wall outlet.
Cord Notch
Foam Filter
www.aquapetfountain.com
Cord Channel
Rubber Gasket
Fig. 20
Fig. 22
Charcoal Filter
13