Prot Ect Ion - Global Air NPA1 Serie Manual De Uso Y Cuidados


Room temperature will automatically show in LE D display with range 10-35℃.

On/Off time can be set.

E1, E2 & E4 protection available (s ee Troubleshooting).

Water-full warning protection.
5. Timer Operation
 Press "Timer" button to set automatic OFF time when unit is running, Timer indicator will light up.

Unit will be off automatically when the set time is ready, and timer indicator is off, room temperature will show
on LED display window.
 Press "timer" button to set automatic ON time when unit is off, Timer indicat or is will light up.

Unit will turn on automatically and working at original mode when the set time is ready, timer indicator will be
off, room temperature is show on LED display window.
 When press "Timer", Timer indicat or will light up, 88 in LED display window will flas h at 0.5 second frequency,
press or
confirmation, then room temperature will show in LE D display window.
Press "Timer" to check time remained when "Timer" function is on; Press "Timer" twice within 5 seconds to

cancel timer.

Only final time setting is effective if repeat ed setting.

The time can be adjusted within a range of 1 -24 hours, press
hour by pressing once.

Unit will not change working mode after timer set. Timer will not stop by other functions.

Timer will be ineffective if any operation from cont rol panel or remote control to turn on or turn of the unit .
3. Remote Control Operation
The Remote control transmits the signal to system.
Button, press this button to start unit when it is energized or stop the unit when it is in operation.
Button, press this button to set unit automatic on and off time
Button, press this button to select high speed of fan running
(except dry and sleep modes)
Button, press this button to select low speed of fan running.
Button, press this button to increase temperature or timer setting.
Button, press this button decrease temperature or timer setting.
Button, press this button to make Celsius degrees and Fahrenheit
degrees interchange.
Button, press this button to select "Cool" mode.
Button, press this button to select "Fan" mode
button within 5 seconds to finish timer setting, set time will flash 5 seconds for
or
8
buttons, to increase or decrease 1