Tabla de contenido
Publicidad
Via Europa, 35 - 20010 Pogliano Milanese (MI) - Tel. 02/9396461 r.a. - Fax 02/93549494
Via del Mare 32/A (interno D) - 00040 Pomezia (Roma) - Tel. 06/9100417 - Fax 06/9100430
PROBLEM
THE HOOD IS DIFFICULT TO OPEN
THE WIRE GIVES OFF SMOKE DURING
SEALING
THE SET TEMPERATURE IS NOT
REACHED
THE MACHINE SEALS BUT DOES NOT
SHRINK-WRAP THE FILM
SHRINK-WRAPPING IS PERFORMED BUT
IT IS IRREGULAR AND INCOMPLETE
THE PACKAGE IS SWOLLEN AFTER
SHRINK-WRAPPING
THE SEALING OPENS DURING SHRINK-
WRAPPING
IRREGULAR SEALING
SEALING IS NOT PERFORMED
Note: If the machine still does not function perfectly after having carried out the aforementioned checks, contact the Service Centre with an
exact description of the fault encountered.
GB
TROUBLE SHOOTING
PROBABLE CAUSE
The room is very cold and the oil in the gas
spring is very viscous, or the spring is partially
released.
Sealing time too long for the type of film used.
Plastic residue on wire.
Heating element broken.
Probe broken (interrupted).
Shrink-wrapping not selected.
The temperature value has been set too low
or the machine is not yet hot enough.
Unsuitable or low-quality film.
The product to be packaged is too large and
takes up the entire resting surface.
The film used is not micro-perforated.
Sealing blade dirty or damaged.
Rubber and/or Teflon worn out.
Sealing time incorrectly adjusted.
Insufficient pressure on the handle of the
hood.
The film used has good shrink-wrapping
characteristics but bad sealing characteristics.
Sealing time set too low.
The sealing wire is broken or not connected
to the clamps.
41
SOLUTION
It will return to normal after a few movements,
or when the machine is warm or – if the spring
is released – move the upper attachment to a
hole further away from the fulcrum of the
sealing frame.
Reduce the value of the sealing time, adapting
it to the type of film used.
Clean.
Replace.
Replace.
Note: in both cases the signal light (6) will
flash after 10 minutes.
Check that the function has been activated.
Increase the setting or wait a few more
minutes or perform a few empty cycles
The film used must be the shrink-wrapping
type.
The dimensions of the product must always
be less than those of the resting surface.
Make the film pass through the micro-piercing
device of the machine
Clean the sealing blade; check that it is resting
correctly in its position and change if
necessary.
Adjust.
Slightly increase the pressure on the handle
of the hood during sealing.
Replace the film.
Adjust according to the type of film.
Check the clamps of the sealing wire and
make sure that the latter is not broken; replace
if interrupted.
DIBIPACK 3246 - 4255 STCN
Publicidad
Tabla de contenido
