HoMedics TotalComfort UHE-WM350 Manual Del Usuario página 8

HOW TO USE
PROGRAMMABLE HUMIDISTAT
The Programmable Humidistat can be set in 5% increments from 35% - 60% humidity.
To program the humidity level, press the Humidistat Button. Then press the + / - Button. The humidity
level will increase / decrease by 5% every time the + / - Button is pressed and will show on the display
screen. Keep pressing the + / - Button until the desired programmable humidity setting is reached. The
display will show the set humidity level for 5 seconds, then default back to display the mist output level.
NOTE: To eliminate any programmed Humidistat setting, press the Humidistat Button. Then press the +
Button until you reach "CO" (continuous on) one level above 60%.
NOTE: When the set humidity level is reached, the humidifier will cycle off until the humidity in the room
drops 5% below the set humidity level, then will cycle on until the set humidity level is reached again.
NIGHT LIGHT / DISPLAY LIGHT
Press the Night Light / Display Light Button once to turn on the night light. The light at the bottom of
the water tanks will turn on, illuminating the tanks. Press a second time to leave the night light on, but
turn off the display light. Press a third time to turn off the night light and display light so no lights are
illuminating. Press a fourth time to turn the display light on.
TIMER
Press the Timer Button. Keep pressing the Timer Button until the desired timer setting is lit on the
display. The Timer Button will cycle through the following settings 0 hours, 2 hours, 4 hours, 8 hours,
12 hours, 0 hours. To turn the Timer off, press the Timer Button until 0 hours is shown on the display.
NOTE: Always be sure the humidifier has a full tank of water prior to using the timer setting.
AUTO-OFF
When the water in the tank is almost empty, the humidifying function will power off to indicate to the user
to refill the tank.
NOTE: It is normal to have a small amount of water in the base during and after use.
AROMA CAPABLE
The aroma feature will function automatically when the mist is turned ON.
8