Configuration And Installation - Black Box IC720A Manual Del Usuario

V.24↔V.35 INTERFACE CONVERTER

3. Configuration and Installation

The converter installs between an RS-232 device
configured as DTE or DCE and a V.35 device configured
as DCE or DTE. (If one device is configured as DTE,
the other device must be configured as DCE, and vice
versa.) You configure the cable to fit your equipment by
moving a jumper on the circuit board inside the RS-232
connector. A typical application appears in Figure 1.
DTE
Synchronous
Terminal
Figure 1. Typical Application of the V.24↔V.35 Interface Converter.
10
Interface X
(V.24)
Interface Y
DCE
(V.35)
Synchronous Modem
or Multiplexor