Introduction - Black Box IC720A Manual Del Usuario

V.24↔V.35 INTERFACE CONVERTER
The V.24↔V.35 Interface Converter connects two data
communications products: one has a V.24 interface and
the other has a V.35 interface. The converter is used in
synchronous applications and operates at data rates up
to 64 kbps. It converts the physical as well as the
electrical interfaces. Its circuitry converts the interface
within short range – use the converter to connect
devices located close to each other (less than 6.5 feet
[2 m] apart).
The converter operates without AC power, using ultra-
low power from the DTE and DCE equipment data and
control signals. It is switch-selectable for one of the
following two applications:
• Connecting a V.24 (RS-232) DTE to a V.35 DCE
• Connecting a V.24 (RS-232) DCE to a V.35 DTE
The converter offers these features:
• Cable and connectors are built into a single unit
• Transparent to protocol
8

2. Introduction