Black Box IC720A Manual Del Usuario página 13

V.24↔V.35 INTERFACE CONVERTER
4. Remove the DTE/DCE socket by gently grasping both
sides and slowly moving it from side to side.
5. Turn the socket around and replace it so that the DCE
side (labeled on the socket) faces the V.24 connector of
the cable and the DTE faces the V.35 device (see Figure
3). Make sure that the pins are aligned with the socket.
Figure 3. V.35 DTE, V.24 DCE.
6. To close the unit, press the two plastic covers together.
To install the converter, plug the RS-232 connector into
your RS-232 device and plug the V.35 connector into
your V.35 device. The converter is now ready for
operation.
12