Selecting And Changing Parameters, Display Mnemonics - Control Techniques COMMANDER SE Puesta En Marcha Rapida

SELECTING AND CHANGING PARAMETERS
Status Mode
(display not flashing)
Parameter View Mode
(left hand display flashing)
Select parameter to change
Parameter Edit Mode
(right hand display flashing)
Change parameter value
NOTE! To return from Parameter Edit mode to Parameter View mode, press the M key once. When
in Parameter View mode - EITHER press the
press the M key to enter Parameter Edit mode OR press the M key to return to Status mode.
LEFT HAND DISPLAY
TRIP CONDITION
DC link under voltage
DC link over voltage
AC instantaneous over current trip
Overcurrent on braking resistor
External trip
Overspeed trip
Auto-tune failure
Ixt on braking resistor
Motor overload on current x time
Overheat (Heatsink thermistor)
Over temperature (Motor thermistor)
+24V or digital output overload
Current loop loss term. 5 (4-20mA, 20-4mA)
EEPROM failure
Stator resistance measurement failure
Phase loss
Comms port supply overload
Overload on current loop input
Internal drive self check failure
* 3 Phase units only
Hold Press
M
M
2 secs
Press
Press
M
Press
DISPLAY MNEMONICS
rd
ih
tr
dc
Fr
SP
Cd
Ld
A
rd 0.0
Press
M
or
Press
M
or
or keys to select another parameter to change, then
Drive has tripped
DC injection braking
SPEED INDICATIONS
Drive output frequency in Hz
Motor speed in RPM
Machine speed in Customer defined units
LOAD INDICATIONS
Drive loading in % of motor rating
Drive output current per phase
RIGHT HAND DISPLAY
3
4 mins
timeout
See NOTE!
STATUS MODE
Drive ready
Drive inhibited
UU
OU
OI.AC
OI.br
Et
O.SP
tunE
It.br
It.AC
Oht2
th
O.Ld1
cL
EEF
rS
PH*
O.Ld2
O.cL
HF