Change Password - Erreka LINK-GSM Guía De Instalación, Configuración Y Uso

3
INSTRUCTIONS FOR CONFIGURATION
Bear in mind the following indications before configuring your system:
• All settings are made by SMS.
• Security is based on the password given to the device
(to change it, see section "Change Password").
• The text of the messages is written in UPPER CAPS,
save for indication to the contrary.
4
CONFIGURATION MESSAGES

The configuration messages described in this section can only be used by the administrators (those telephone numbers
which have been registered as administrators). There is a maximum of 5 administrators.

The telephone numbers shown in the examples have been partially concealed with an "X" for privacy reasons.
Administrator Registration
The system admits up to 5 telephone numbers with
administrator privileges. Only these authorised numbers
can register and remove, configure the relays, list and
number the registered telephone numbers, etc.
Remove Administrator

Change Password

• The word "key" in the commands means the
system's current password should be entered.
• If you only wish to open doors/gates, programme
just the authorised telephone numbers.
• If the GSM module is to be reset to default values,
send the command RESTART MEMORY-key.
The format of the message to be sent is as follows (the
telephone numbers must be separated by commas):
ALTA-nº tel1,nº tel2,nº tel3,nº tel4,nº tel5-ADMIN-key
These 5 telephone numbers have been registered in
Relay 1, meaning any missed calls will enable Relay1 of
the GSM module.
If the module is connected to a VIVO-D203, VIVO-M203
or VIVO-M204 control panel, ST1 will also be activated
(total opening with F100 or F101). These 5 telephone
numbers can also activate both Relay 1 and Relay 2 via a text
message (SMS).

Any administrator (duly registered) may register or
remove other installers, in addition to users.
The message format to be used to remove an
administrator is as follows:
BAJA-nºtel1,nºtel2,nºtel3,nºtel4,nºtel5-ADMIN-key
A maximum of 5 administrators can be removed at one
time.
The telephone number removed as the administrator in
the GSM module will remain as an authorised number
but without the option of activating Relay 1 (by calling)
or of activating any relay by SMS message.
The default access key or password is 0000. Changing
this password is recommended (must be registered as
an administrator). The message format is as follows:
CLAVE-old key-new key

If the memory is
message, as shown below), the key also restarts and
the default value is restored (0000).

Be sure not to forget the new password.
(by RESTART MEMORY
29