Relay Configuration - Erreka LINK-GSM Guía De Instalación, Configuración Y Uso

Relay Configuration


This relay configuration can only be carried out by
the system administrator or administrators.
32
The relays can be configured differently for missed call
or SMS message:
A missed call activates the relay impulsively and
activation time can be configured from a minimum of 1
second up to a maximum of 240 seconds (1 second is
activated by defect).
Each relay can be configured independently:
MODOLLAMADA-RELE1-PULSO-time
Send the following text message (time in seconds) to
configure the activation time of the two relays:
MODOLLAMADA-RELE1,RELE2-PULSO-time
Text messages can also be used to activate the relays
impulsively or in bi-stable mode:
The following message is used to configure the relays
to work impulsively:
MODOSMS-RELE1,RELE2-PULSO-time (seconds)
Activation time for the relay goes from a minimum of 1
second up to a maximum of 240 seconds. By default the
relay is activated for 1 second. The relays can be
configured independently or both at the same time.
An SMS with the following text should be sent to
configure the relays to work in bi-stable mode:
MODOSMS-RELE1,RELE2-FIJO
The relays can be configured independently or both at
the same time.
After configuring the relays in SMS mode, the users
added with the SMS option can activate them, disable
them and know their status using the CONNECT,
DISCONNECT and STATUS messages, as described
above.