Important Safeguards - CiA PCM100 Manual De Usuario

PCM100 / PCM130 - User Manual

Important Safeguards

Please read this manual carefully before the installation and keep it for future reference.
Installation, electrical connections and adjustements must comply with technical and safety standards
in force. (UNI 8612).
HILTRON Srl cannot be held responsible for failure to observe technical standards in the construction of gates, or for
any deformation of gates which may occur during the use.
This product has been designed and manufactured only for the use stated in this manual. Any other use not expressly
set forth will affect the reliability of the product and/or could be source of hazard.
HILTRON Srl cannot be held responsible for any damage caused by improper use or different from the use for wich the
autamtion system is destined to.
Do not use this device in areas subject to explosion: the presence of flammable gas or fumes is a serious hazard.
Before carrying out any operations, turn off the system's main switch.
An omnipower switch shall be provided for the installation with an opening distance of the contacts of 3 mm or more.
Alternatively, use a 6A thermomagnetic breaker with a multi-pole switching.
Ensure that there is a differential switch up-line of the electrical system, with a trip threshold of 0.03A.
Check that the earthing plant is in perfect condition and connect it to the metallic parts. Also earth the Yellow/Green
wire of the operator.
The end-user must avoid any attempt to repair or adjust the automation personally. These operations must be carried
out only by qualified personnel.
For maintenance operations, use only CIA original spare parts produced by HILTRON Srl. Do not carry out any
modifikeptcations to automation components. Packaging materials (plastic, cardboard, etc.) are a potential hazard
and must be out of reach of children.
The installer must supply all informations regarding manual operation of the system in the event of an emergency and
provide the end-user with this manual attached to the product.
The automation is fitted with an anti-crush safety system that is a torque control device.
In any case, HILTRON Srl suggests the installation of others safety devices, in accordance with standards in force,
system operating logic and weight and dimension of the gate.
The safety devices (i.e.: photocells, pneumatic edges, etc...) protect areas wherethere is a mechanical movement
hazard (i.e.: crushing, entrapment and cutting). Each installation must be fitted with at least one flashing light (i.e.: item
LAMP12FG) or with at signalling plate (i.e.: item TRG CIA) fixed to the gate.
HILTRON Srl cannot be held responsible regarding safety and correct operation of the automation in the event that
parts other than CIA original parts (produced by HILTRON Srl).
18