Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
3.8
Remote-control setup
The TWIN allows the independent set-up for each of 2 channels;
memorize a different code on each button, and a channel to select (A, or B) also if they
are not on the same code.
The set-up operation has to be repeated for each of the 2 buttons of the radio-
control.
In order to start the set-up phase you have to push both the buttons for some
, until the LED remains on, then you have to leave them:
seconds
For insert the code you have to access with digit the following sequence: "1" - "1" - "0" - "0"
For insert the 10 digit of the code use:
"0" (right button ): It means dip-switch "OFF" for the previous TWIN
versions*
"1" (left button): It means dip-switch "ON" for the previous TWIN
versions*
During the insert of each code the LED will switch off for some seconds.
For insert the
Channel A
Channel B
Push the button that you want to assign at the code.
The LED switch off at the end of the set-up.
*
For example, to setup a new code or duplicate a TWIN of previous version that has dip-switch setted as below:
You have to digit the following buttons sequence:
1
1
0
0
Access
1
1
0
0
Access
For read the code you have to digit
In order to start the set-up phase you have to push both the buttons for some
seconds uring the set-up, if you don't push on any button for at least 5 seconds
, d
the LED switch off and the setting phase finish automatically. the following
sequence:"1" - "0" - "1" -"0"
Push on the button that you want to know the code (A or B)
The LED switch off and it start one series of 12 flashes:
A brief flash means
A long flash means
Unscrew the screw on the bottom of the radio-control to open the plastic cover, take off the old battery
and insert a new one according with the polarities indicated on the plastic cover.
Check the correct operation of the two buttons after to close the plastic cover.
2 digit of the channel use:
"1" - "0": It means the left button for the previous TWIN versions
"1" - "1": It means the right button for the previous TWIN versions
1
2
ON
OFF
1
0
0
1
1
0
1
code
1
0
0
1
1
0
1
code
"0"
"1"
5
3
4
6
7
8
0
0
1
1
0
channel A
0
0
1
1
0
channel B
It's possible to
9
10
(fast flash of the LED)
assigned to left button
(fast flash of the LED)
assigned to left button
Setup
1
0
31
Publicidad
Capítulos
Tabla de contenido
