Iii.3.A Induction Hob Installation - Galvamet KompaKOne Manual De Instrucciones

EN
III.3.a INDUCTION HOB INSTALLATION
To leave the necessary space for the air pipe it is important to install the induction hob
with the center line at more than 360mm distance from a possible wall on the back.
Installation of the induction hob can be flush or non-flush.
For non-flush installation: drill the worktop as shown at Fig. 3.29
Fig. 3.29
For flush installation: drill the worktop and mill it all along the edge of the hole, following
sizes indicated Fig. 3.9.
Fig. 3.9
23