Replacing Vacuum Bag And Filters - Riccar sunburst Instrucciones De Seguridad Importantes

Replacing the Vacuum Bag
Replacing the Secondary Filter
1. Open the bag compartment and locate the
filter behind the vacuum bag. For better
access to the secondary filter, remove the
bag holder and bag.
2. Slide filter holder up and out.
3. Remove the used filter and replace it with
a new filter.
4. Slide the filter holder back in place and
replace the bag holder and bag.
Replacing the HEPA Media Filter
1. Locate the HEPA media filter inside the bag
compartment near the door hinge.
2. Press the black tab to remove the used filter
and snap in a new filter. NOTE: The HEPA
media filter cannot be washed and reused.

Replacing Vacuum Bag and Filters

Change the vacuum bag when the indicator is RED or
suction power is weak. The dust cover will not close
without a bag in the unit or if the bag is not properly
installed.
1. Pull the bag holder straight out to access the bag.
2. Remove and discard the used bag. NOTE: The HEPA
media bag cannot be reused. Do not throw away the
bag holder.
3. Secure the new bag with the bag collar holder latch.
Slide the tab on the bag holder into the slot on the
front of the bag compartment.
5