Parts Required - Escalade Sports Atomic Instruction Manual

PARTS REQUIRED:

2 pcs - P1 Side Apron
1 pc - P3 Playfield
STEP 1:
Find a clean, level place to begin the assembly of your
soccer table. We recommend building the table on the
box top to protect the parts during assembly.
It is very important to assemble table on a level and
flat surface. This will keep the end aprons and side
aprons "FLUSH" on the top and bottom edges.
Set P3 Playfield into the grooves in P1 Side
Apron as shown in FIGURE 1.
IMPORTANT NOTE: Be sure playfield is
centered before installing any H4 Screws.
8 pcs - H1 Allen Head Bolt
8 pcs - H3 Flat Washer
STEP 2:
Attach P2 End Aprons onto P1 Side Apron using H1 Allen Head Bolts with H12 Lock Washers and H3 Flat Washers
as shown in DETAIL A. Do not tighten H1 Bolts on this time.
Slide P12 Corner Posts on the each end of P1 Side Apron and P2 End Apron. Center P3 Playfield and tighten H1
Bolts using T1 Allen Wrench.
Use H7 Screws to secure P12 Corner Post as shown in FIGURE 2. Tighten, but do not strip out H7 Screws.
ATTENTION:
THIS STEP REQUIRES TWO OR MORE ADULTS.
VERY CAREFULLY ATTACH P12 CORNER POST
ONTO EACH P1 & P2 APRON.
VERY IMPORTANT! DO NOT TIGHTEN H1 BOLTS AT THIS TIME.
THE P12 CORNER POSTS MUST BE INSTALLED BEFORE
TIGHTENING THE H1 BOLTS. INSTALLATION OF THE P12
CORNER POSTS WILL SQUARE UP THE SIDE AND END APRONS
FOR CORRECT ASSEMBLY.
TIGHTEN THE H1 BOLTS ONLY AFTER THE P12 CORNER POSTS
ARE CORRECTLY INSTALLED.
NOTE: P12 Corner Post
should be flush with
bottom of P1 Side and
P2 End aprons.
P12
All Rights Reserved.
© 2012 Escalade Sports
THIS STEP REQUIRES TWO OR MORE ADULTS.
VERY CAREFULLY SET P3 PLAYFIELD INTO THE GROOVES
8 pcs - H7 Phillips Round Head Screw
8 pcs - H12 Lock Washer
P1
P2
P12
ATTENTION:
IN P1 SIDE APRON.
Groove
P1
NOTE:
Graphic on this side.
PARTS REQUIRED:
2 pcs - P2 End Apron
4 pcs - P12 Corner Post
H7
5
P1
NOTE: Install P12 Corner Posts
P12
with arrow pointing down.
H7
P2
P1
IMPORTANT NOTE: Center P3 Playfield
before tightening H1 Bolts.
For Customer Service Call 1-888-996-2729
P3
FIGURE 1
1 pc - T1 Allen
Wrench
H3
H12
H3
H12
H1
DETAIL A
P12
FIGURE 2