Escalade Sports Atomic Instruction Manual página 8

6 pcs - H6 Phillips Round Head Screw
8 pcs - H9 Phillips Flat Head Screw
2 pcs - P9 Playfield Trim
STEP 6:
Peel the adhesive strip protective coating off the underside of P9 Playfield Trims, then very carefully place them
along P3 Playfield as shown in FIGURE 6.
Carefully peel paper protective coating from adhesive strips from the back of P11 Corner Caps to reveal adhesive
strips. Attach P11 Corner Caps using H9 Screws as shown in FIGURE 6.
Tighten, but do not strip out H9 Screws.
Attach P13 Scorers onto the top of P2 End Apron as shown in FIGURE 6.
Insert P17 Rod Bushings onto both P1 Side Aprons as shown in FIGURE 6.
Please make sure to insert P17 Rod Bushings from the inner side of P1 Side Apron for correct assembly.
IMPORTANT NOTE: P17 Rod Bushings may require the use of a rubber hammer for installation into side apron.
With a rubber hammer, lightly tap bushing squarely into place. DO NOT USE STEEL HAMMER!
If a rubber hammer is not available, place a piece of wood squarely on bushing and lightly tap into place.
Attach P18 Ball Entry Cups using H6 Screws as shown in DETAIL C.
Tighten, but do not strip out H6 Screws.
Carefully - Tap P24 Cup Holders down into P2 End
Aprons as shown in FIGURE 6.
Note:
Red Bead scorer should
be on opposite side of
Ball Return.
All Rights Reserved.
© 2012 Escalade Sports
PARTS REQUIRED:
P9
Rubber
Hammer
P13
P11
H9
4 pcs - P11 Corner Cap
2 pcs - P13 Scorer
16 pcs - P17 Rod Bushing
P17
H9
FIGURE 6
8
2 pcs - P18 Ball Entry Cup
4 pcs - P24 Cup Holder
P13
Note:
Red Bead scorer should
be on opposite side of
Ball Return.
P24
Note:
Carefully tap P24
Cup Holders down.
DETAIL C
P18
For Customer Service Call 1-888-996-2729
H6