Watts BT-M6Z02-RF 230V Guia Del Usuario página 9

6.B. Installation with Touchscreen BT-CT02-RF
If there is a Touchscreen BT-CT02-RF in the installation, everything is centralized by the Touchscreen.
In this configuration, proceed with the RF link in this order:
Element 1 to link
BT-M6Z02-RF
Press OK for 5 seconds, first channel
LED must blink.
Choose the channels with < and > and
select/deselect the zone with OK.
When a zone is selected it turns Red.
Note: To exit, press OK for 5 seconds.
BT-M6Z02-RF
Press < for 5 seconds, all channel leds
must blink Green. Product is waiting for
link.
Note: To exit, press < for 5 seconds.
Exemple of an "Centralyzed Installation"
Element 2 to link
BT-D03 RF / BT-D(P)02-RF /
BT-A02-RF
Thermostats :
Put product in RF Link mode
(refer to correspondant
instruction manual)
BT-HCM02-RF
Put product in RF Link mode.
9
Comments
If link is done, the leds of channels
selected on the BT-M6Z02 RF
must turn Green and the
thermostats must exit the link
mode.
When link is done BT-M6Z02-RF
And BT-HCM02-RF return to
normal mode.
REMARK: only one BT-HCM02-
RF in the installation