Media Installation - Dimplex 6908760100 Manual Del Propietário

Fireplace Installation
Figure 5
a #2 Phillips screwdriver into
the recess of the anchor.
9. Press the anchor into the wall
in the desired marked position
while turning the anchor
clockwise until it is flush with
the wall.
10. Insert the wall anchor screws
through the wall bracket and
thread into the wall anchors.
Tighten the screw.
11. Install the remaining screw
through the bracket and into
the wall stud.
!
NOTE: At least one of the
screws must be installed into a
wall stud.
12. Mount the unit on the wall,
so that the tabs on the wall
bracket have been inserted
into the slots on the back of
10
Figure 6
Media Tray
the firebox. (Figure 5)
13. Excess electrical cord can be
inserted back into the bottom
of the unit, into the cord
storage area.

Media Installation

Depending on the model, the
media may come installed in the
unit, packaged seperately or have
option of being interchanged.
Installed Media
• No additional steps are
required.
Media Seperately Packaged
• Solid Media: Place media
piece on top of tray. (Figure 6)
• Loose Media: Carefully pour
and evenly distribute the
media in the Media tray of the
firebox.
www.dimplex.com