Mirrored Glass Installation; Media Arrangement - Dimplex XLF50 Guía De Instalación Y Del Usuario

Installation

Mirrored Glass Installation

1. Locate and remove the screws securing the mirrored glass bracket to the unit, along the top of the opening, and
set bracket and screws aside. (Figure 11)
2. Remove the provided suction cup from the inside cavity of the unit (not found in XLF50 units).
3. Ensure that the back of the glass is clean and free from particles and fingerprints.
4. Secure the suction cup to the mirrored glass on the reflective side
5. Lift the mirrored glass and place it into the supports on the bottom at either side of the unit.
6. Tilt the mirrored glass into a vertical position.
7. Secure the mirrored glass bracket to hold the glass in place, using the previously removed screws.
CAUTION: Ensure the mirrored glass does not fall forward while the mirrored glass mounting bracket is being
installed.
8. Remove the suction cup and clean any fingerprints or debris off the glass with a non-abrasive glass cleaner.
!
NOTE: Do not dispose of the suction cup! Keep it in a secure location, as it may be needed for maintenance and
service on this fireplace.

Media Arrangement

For best results when using the supplied media, arrange
as follows:
1. Evenly space the large media in the media tray along
the back of the media tray
2. Pour and evenly distribute the smaller crystals into the
media tray.
3. If using the optional driftwood and river rock kit,
evenly disperse the river rocks and place the
driftwood pieces on top.
It is possible to use custom media ornaments to decorate
your firebox. The custom media must fit easily without
scratching the glass or bowing the media bed, and must
not be composed of sand or liquid, which could interfere
with the safety of the firebox.
Figure 11
Mirrored Glass
Supports
Mirrored Glass
Mirrored Glass
Bracket
Media Tray
Figure 12
15