Removing Doors - Sears Kenmore 57082 Manual De Instrucciones

Models 57582, 57587, 57542, 57547
Pry up edge of handle trim using a putty knife, with
the blade end covered in masking tape. Remove
handle from door by removing 2 mounting screws at
each end of handle.
Handle trim
Screw-
Screw
Handle trim
2. To replace handle, mount handle to door with 2
mounting screws. Snap handle trim in place over
ends of handle.
Models 57082, 57085, 57089
1. Pry up edge of handle trim by inserting screwdriver
with the blade covered in masking tape, under top
edge of handle trim and pry upward as you work
your way down the handle. Remove handle cap from
top of handle.
• Pry up bottom edge of dispenser facade on
freezer door. Pull facade out of dispenser cavity
before removing freezer door handle trim.
(Dispenser units only.)
2. Remove 6 handle screws with 1/4"nut driver.
3. Remove handles from door.
.
6 hex head
handle screws
Replace handle by performing steps 2-3 in reverse
order. Replace handle trim by snapping back in place
over handle trim.
Removing Doors
Some installations may require door removal to get the
refrigerator into the home. If so, perform the following
steps:
.
2.
Remove toe grille.
Loosen water tube clamp screw. Loosen plastic
water tube union nut. Pull water tube away from
union nut and through tube clamp.
Plastic water tube
union nut
Nater tube
Water tube clamp
_crew