Genius SPRINT 03 Manual Del Usuario página 17

5.. TERMINAL BOARD CN
5.1.1. p 22V
ower supply
Terminals "VAC – VAC". Connect the transformer secondary circuit to this input with power supply of 24Vac 50/60 Hz.
Presence of power supplied by the transformer is signalled by the lighting up of the "POWER" LED.
5.1.2. B
Atteries
Terminals " +BAT – BAT". Connect the buffer batteries (optional) power cables to these terminals. The control unit is
designed to operate with two buffer batteries, with the minimum characteristics shown on the table of paragraph 2.
During normal operation, the control unit keeps the batteries charged. They enter into operation if no power is supplied
to the transformer.
Power supply from batteries only should be considered an emergency situation. The number of possible
manoeuvres is linked to the quality of the batteries, the structure of the gate to be moved, how long ago the
power cut occurred, etc, etc..
Observe the battery supply polarity.
4. BOARD LAY-OUT
5. CONNECTIONS AND OPERATION
5
COMPONENTS COMPONENTS
CN1 CN1 Power supply terminal-board Power supply terminal-board
CN2 CN2 Outputs terminal-board Outputs terminal-board
CN3 - CN4 Inputs terminal-boards CN3 - CN4 Inputs terminal-boards
CN5 CN5 Receiver coupling Receiver coupling
P1 - P2 P1 - P2 Programming push-buttons Programming push-buttons
RESET RESET Reset push-button Reset push-button
F1 F1 Power supply protective fuse Power supply protective fuse
F2 - F3 - F4 Self-resetting fuses F2 - F3 - F4 Self-resetting fuses
LCD LCD Display Display
POWER POWER LED: Power ON LED: Power ON
STOP STOP LED: STOP input status LED: STOP input status
FSW CL FSW CL LED: FSW CL input status LED: FSW CL input status
FSW OP FSW OP LED: FSW OP input status LED: FSW OP input status
FCC FCC LED: FCC input status LED: FCC input status
FCA FCA LED: FCA input status LED: FCA input status