Genius SPRINT 03 Manual Del Usuario página 20

No safety device connected No safety device connected
A pair of photocells for closing, and a pair for opening A pair of photocells for closing, and a pair for opening
6. INSTALLING THE RADIO CONTROL RECEIVER BOARD
The control unit is designed to house a 5-pin radio-receiver module. Installation procedure: turn off electrical power
and fit the module in connector CN5 on the control unit.
To avoid damaging the receiver and thus irreparably compromising its
operation, the receiver must be installed, observing the fitting direction
specified in the figure at the side.
Follow the instructions of the radioreceiver to memory-store the radiocontrol.
A pair of closing photocells A pair of closing photocells
A pair of photocells for opening, a pair for closing and A pair of photocells for opening, a pair for closing and
a pair for opening and for closing a pair for opening and for closing
8