Preparation - Honda WX10T Manual De Explicaciones

36YH46000.book 9 ページ ２０１４年８月２８日 木曜日 午前１１時７分
Before each use, look around and underneath the engine for signs of oil
or gasoline leaks.
1.Install the hose connector.
Be sure to check that the hose coupling packing is seated in its place
and install the hose connector to the suction port on the pump.
SUCTION PORT
2.Connect the suction hose.
Use a commercially available 25 mm (1.0 in) diameter hose. The
suction hose must be of reinforced, noncollapsible construction.
Suction hose length should not be longer than necessary, as pump
performance is best when the pump is not far above the water level.
Self-priming time is also proportional to hose length.
The strainer that is provided with the pump should be attached to the
end of the suction hose with a band, as shown.
CAUTION:
Always install the strainer on the end of the suction hose before
pumping. The strainer will exclude debris that can cause clogging or
impeller damage.
HOSE CONNECTOR
HOSE COUPLING
PACKING
HOSE BAND
SUCTION HOSE
(Commercially available)

4. PREPARATION

HOSE COUPLING HOSE CLAMP
RING
STRAINER
HOSE BAND
9