Preparation - Honda WX10T Manual Del Propietário

Before each use, look around and underneath the engine for signs of oil or
gasoline leaks.
1. Install the hose connector.
Be sure to check that the hose coupling packing is seated in its place and install
the hose connector to the suction port on the pump.
2. Connect the suction hose.
Use a commercially available 25 mm (1.0 in) diameter hose. The suction hose
must be of reinforced, noncollapsible construction. Suction hose length should
not be longer than necessary, as pump performance is best when the pump is
not far above the water level. Self-priming time is also proportional to hose
length.
The strainer that is provided with the pump should be attached to the end of
the suction hose with a band, as shown.
CAUTION:
Always install the strainer on the end of the suction hose before pumping.
The strainer will exclude debris that can cause clogging or impeller
damage.
SUCTION PORT
HOSE COUPLING
PACKING
HOSE BAND
SUCTION HOSE
(Commercially available)

4. PREPARATION

HOSE CONNECTOR
HOSE COUPLING HOSE CLAMP
RING
STRAINER
HOSE BAND
9