Mobile Home Installation; Section 10: Mobile Home - Pleasant Hearth PH35PS Manual Del Usuario

Ocultar thumbs Ver también para PH35PS:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

10
Mobile Home
A. Mobile Home Installation
You must use an authorized Outside Air Kit
for installation in a mobile home.
1.
An outside air inlet must be provided for the combustion
air and must remain clear of leaves, debris, ice and/or
snow. It must be unrestricted while the appliance is
in use to prevent room air starvation which causes
smoke spillage. Smoke spillage can also set off smoke
alarms.
2.
The combustion air duct system must be made of
metal. It must permit zero clearance to combustible
construction and prevent material from dropping into
the inlet or into the area beneath the dwelling and
contain a rodent screen.
3.
The appliance must be secured to the mobile home
structure by bolting it to the floor (using lag bolts)
with two attachment points. Use the same holes that
secured the appliance to the shipping pallet.
4.
The appliance must be grounded with #8 solid copper
grounding wire or equivalent, terminated at each end
with an NEC approved grounding device.
5. Refer to Clearances to Combustibles and floor pro-
tection requirements for listings to combustibles and
appropriate chimney systems.
6.
Use silicone to create an effective vapor barrier at
the location where the chimney or other component
penetrates to the exterior of the structure.
7.
Follow the chimney manufacturer's instructions when
installing the vent system for use in a mobile home.
8.
Installation shall be in accordance with the Manufactur-
ers Home & Safety Standard (HUD) CFR 3280, Part
24.
WARNING
Installation must comply with Manufactured Home and
Safety Standard (HUD), CFR 3280, Part 24.
WARNING
Asphyxiation Risk.
NEVER INSTALL IN A SLEEPING ROOM.
Consumes oxygen in the room.
32
THE STRUCTURAL INTEGRITY OF THE MOBILE HOME
FLOOR, WALL AND CEILING/ROOF MUST BE MAIN-
TAINED
Do NOT cut through:
• Floor joist, wall, studs or ceiling trusses.
• Any supporting material that would affect the structural
integrity.
Joist Shield/Firestop
7077-171I • December 08, 2016
CAUTION
CAUTION
Never draw outside combustion air from:
• Wall, floor or ceiling cavity
Enclosed space such as an attic, garage or
crawl space.
Storm Collar
Spark Arrestor Cap
Roof Flashing
Approved Class "L"
or "PL" Pellet Vent
(877) 447- 4768

Publicidad

Capítulos

Tabla de contenido

Solución de problemas

loading

Este manual también es adecuado para:

Ph50psPh50cabpsPh35ps seriePh50ps seriePh50cabps serie

Tabla de contenido