Tabla de contenido
Publicidad
3. Basic Operation
3.1 Power Up
Plug in the power cable and turn the unit ON. It will conduct a self-check by
spinning the rollers while the unit tests all the electronic parts.
As soon as the unit's display shows "0", the unit is ready to start counting.
In case any error message comes out in the display, refer to the troubleshooting
chapter.
3.2 Counting Mode
Once the bills are correctly placed in the hopper, the unit will start counting
automatically. The number of counted bills will be shown on the display.
3.3 Functions Selection
Select the function you want to use by pressing the specific button on the key-
board:
a) UV and MG functions are used to verify the authenticity of each note. Press-
ing them sequentially, the display will show you the available options for these
functions.
b) ADD and BATCH functions are used for addition and batch operations re-
spectively.
3.4 Manual Value Extension function ( DEN )
This function allows the user to select the DENOMINATION of the notes to be
counted in order to obtain the TOTAL AMOUNT of money counted.
3.5 REPORT/ PRINT function
The unit will show on the display a breakdown list with the quantity of bills and
the amount of money per denomination.
This Report could be printed if required by the user.
12
Publicidad
Tabla de contenido
